Setting The Height Of The Ames; Switching O The Appliance; Failure; Control (Manual Control) - WANDERS Solea Elegance Mode D'emploi Et Instructions D'installation

Setting the height of the ames

• After igniting the burner, the height of the ames will automatically reach the maximum position.
• Press button  continuously to lower the ames and to switch o the burner (putting the re out: "STAND
BY"). Press button  brie y to gradually lower the ames.
• Press button  to increase the ame height. Brie y press button  to gradually increase the ames.

Switching o the appliance

• Press button  to lower the ames and to switch o the burner.
• Then press "OFF" button  to switch o the entire unit, including the pilot ame.
• If the appliance is not used for a longer period it is advisable that you turn o the gas valve in the gas pipe.
Important: if the pilot ame has gone out for whatever reason, you must wait at least 5 MINUTES
!
before lighting the pilot ame again.

Failure

If it looks as if the signals of the remote control are not properly received by the stove (receiver), it may be
caused by:
• Empty batteries: change the batteries.
• An electronic problem: solve it by pressing the "RESET" button on the receiver.
• If the appliance often switches o you should contact your installer.

Control (manual control)

If the batteries are due for replacement or if the receiver is defect, you can also operate the hearth by hand.
To do so, you need to disconnect the ignition (piezo) cable of the receiver and slide it gently onto the piezo
connection of the gas control block.
Lighting the re and putting it out
1. Open the gas stopcock which is mounted in the gas pipe leading to
the appliance.
2. Press "O I" switch  on the gas control block in the "I" position.
3. Turn motor switch  on the gas control block all the way to the right.
The switch will make a ticking sound.
4. Turn operating switch  on the gas control block in the MAN
position; an ori ce  becomes visible.
5. Push the metal pin in the ori ce with something like a small pen. The
gas will now ow to the pilot.
6. While keeping the metal pin pressed in, press the (square) ignition
fuse  (next to the "O I" switch) to ignite the pilot ame. Look through
the glass to see whether the pilot ame is burning.
7. If the pilot ame is burning, keep the metal pin pressed for another
10 seconds and then release it. If the pilot ame dies, wait for another
5 minutes before repeating the above steps.
8. Turn operation knob  to the "ON" position.
9. Turn motor switch  to the left to ignite the burner and to select the
height of the ames.
10. Turn motor switch  all the way to the right to put out the re; the pilot ame will keep burning.
11. If you want to put out the pilot ame as well, turn "O I" switch  to the "O" position.
12. Close the gas tap.
20
All manuals and user guides at all-guides.com




