Setting The Height Of The Flames; Switching Off The Appliance; Failure - WANDERS Square 60 G Mode D'emploi Et Instructions D'installation

is not in the "I" position.
• 5 short signals (0.2 sec. signal with 0.2 sec. interval) : ignition of the pilot flame and the main burner has
failed. Possible cause: air in the pilot burner pipe.
Important: If the pilot flame has gone out you must wait at least 5 MINUTES before repeating the
!
above-mentioned steps.

Setting the height of the flames

• After igniting the burner, the height of the flames will automatically reach the maximum position.
• Press button  continuously to lower the flames and to switch off the burner (putting the fire out: "STAND
BY"). Press button  briefly to gradually lower the flames. Double-click on button  to let the burner go
to its lowest mode (LO).
• Press button  to increase the flame height. Briefly press button  to gradually increase the flames. Dou-
ble-click on button  to let the burner go to its highest (HI) position.

Switching off the appliance

• Press button  to lower the flames and to switch off the burner.
• Then press "OFF" button  to switch off the entire unit, including the pilot flame.
• If the appliance is not used for a longer period it is advisable that you turn off the gas valve in the gas pipe.
Important: if the pilot flame has gone out for whatever reason, you must wait at least 5 MINUTES
!
before lighting the pilot flame again.

Failure

If it looks as if the signals of the remote control are not properly received by the stove (receiver), it may be
caused by:
• empty batteries: change the batteries.
• an electronic problem: solve it by pressing the "RESET" button on the receiver.
• If the appliance often switches off you should contact your installer.
20
C
MAN

C
MAN
