General Information; Ready For Use; Lighting The Pilot Flame Manually; Arranging The Height Of The Flames - WANDERS Square 40 G Mode D'emploi Et Instructions D'installation

General information

It is common practice for the dealer where you purchased your gas unit to take also care of installing it and
connecting it to the mains. If this is not the case, please ensure that the installation is done by a certified
installer. Connecting gas devices by unqualified persons is prohibited, in which case we cannot give any
guarantee that your gas hearth is functioning properly.

Ready for use

After connecting your Wanders gas unit to the mains and making the necessary adjustments, the hearth is
ready for use. The pilot flame must be ignited manually.
Receiver

Lighting the pilot flame manually

1. Remove the front frame by pulling it towards you and then lifting it as
shown on the image.
2. You're now able to see the controls as shown on the images above.
3. Turn the ignition knob (A) until it stops (spark symbol / IGN), then press
the knob and wait a few seconds.
4. While keeping the knob pressed, turn the knob to the left until you hear
a click.
5. Look through the glass pane to see whether the pilot flame is burning. If
the pilot flame is not ignited, repeat steps 3 and 4.
6. If the pilot flame is burning, keep the ignition knob pressed for some time.
When you release the knob after 30 seconds, the pilot flame must stay
alight. If it doesn't, wait for 5 minutes before trying to light the pilot flame
again.
7. If the pilot flame stays alight, turn the knob anticlockwise till the symbol of the large flame. Now you can
close the flap and regulate the height of the flames with the remote handset.
Child-proof safety lock
!
If you turn the ignition knob to the symbol of the small flame, the remote control is put out of action
while the pilot flame will stay alight.

Arranging the height of the flames

Point the remote control handset towards the gas unit. The hearth will burn higher when pressing the 
button. The hearth will burn slower when pressing the button. When you keep pressing the  the hearth
will switch to the pilot flame position. You can also put the hearth on the pilot flame position manually by
turning the ignition knob (A) until the minimum is reached (small flame / PILOT).
18
Gas governor (A)