Switching Off The Pilot Flame; Lighting The Hearth For The First Time - WANDERS Square 40 G Mode D'emploi Et Instructions D'installation

When you press both buttons, you will see the 'transmit' signal top left on the display.
The hearth has reached its highest or lowest position when the LED of the receiver
starts blinking.

Switching off the pilot flame

The pilot flame is switched off manually. Remove the frame, gently press the ignition
knob (A) and then turn it towards the dot / OFF indiciation.

Lighting the hearth for the first time

When you light your gas unit for the first time, the hearth must 'anneal' . The unit has
a heat resistant lacquer which must still burn in. Though this may give an unpleasant smell, it is otherwise
harmless. It is advisable to turn onto high for about three hours while airing the room well.
Discolouration of walls, ceilings and grates
!
After lighting your heath the walls, ceilings and grates may show some discolouration. This is caused
by the dust particles that burn in the convection cover. This is a natural process for which WANDERS
cannot be held responsible. To minimize the discolouring we refer to the advice given for atmospheric
hearths. Your installer can give you more information about this.
Some deposit may form on the ceramic glass of the door of the hearth. You can easily remove this deposit with
a damp cloth and if necessary some cleansing agent for ceramic rings when the glass has cooled down. On
page 25 you'll find a description on how to open the door and remove the glass.
Avoid finger marks
!
Avoid leaving any finger marks on the glass after closing the door. Finger marks leave stains that burn
in the glass and cannot be removed later.
When you light your fireplace for the first time, the unit calculates how much time is needed to reach the pre-
set temperature. Your hearth will now select the most efficient way to heat the room.
Ensure that the logs are not placed in front of the pilot flame. The gas must be able to stream freely to
!
the main burner. The main burner is located underneath the log set. See page 20 for placing the log
set properly.
It is advisable to keep the pilot flame burning in heating seasons to prevent condensation and possible
calcification on the inside of the door.
Newly-built house or recently renovated?
!
It is advisable to wait six weeks before lighting the hearth in a newly-built house that has recently been
delivered, or a space or room that has recently been drastically renovated. The walls and ceilings still
contain gases, softeners and moist from plasterwork or paint. The warm air-streams may discolour
the dust particles in the space which may stick to walls and ceilings. When the moist in the walls and
ceilings warm up, this may also cause yellowish stains.
19