Placing The Logs Or Pebbles - WANDERS Square 40 G Mode D'emploi Et Instructions D'installation

Placing the logs or pebbles

!
To avoid any problems, the layout of the logs needs to be exactly as shown on the images
Placing the ceramic lumber set (only for natural gas)
• Place some pieces of ceramic bark exactly as shown in the illustrations. Start with four pieces of bark on
the burner but do not block the outflow passage of the pilot.
• Place the ceramic logs exactly as shown in the illustrations. This will give regular flames and prevents soot
build-up.
• Place the rest of the bark in the empty spaces around the logs. Do not place them on the burner.
Be sure not to touch the cleaned glass with your fingers when you replace the pane. Finger marks burn
!
in the glass.
Do not forget to replace the door correctly and close it before lighting the hearth.
Placing the ceramic pebbles (available for natural gas and propane)
• First put four stones on the burner (see illustration).
• Make sure that the outflow passage in front of the burner is not blocked.
• Then fill up the rest of the bottom with the stones (see the illustration).
• Make sure that the outflow passage in front of the burner is not blocked.
28