Setting The Desired Temperature; Checking The Set Temperature; Timer; Man - WANDERS Square 40 G Mode D'emploi Et Instructions D'installation

Setting the desired temperature

Press and hold the AUTO button until the TEMP indication blinks. You can set a higher temperature with the
 button and a lower temperature with the  button. Then wait a few seconds, or press the AUTO button to
switch to the automatic modus.

Checking the set temperature

Briefly press the AUTO button. The display briefly shows the pre-set temperature and then displays the room
temperature.

TIMER

You can pre-set a total of four time-settings. When you link up all four time-settings, you can be sure of a
comfortable room temperature at all times.
Press and hold the TIMER button until the indication P1<> blinks. With the  and  buttons you can set
respectively the hours and the minutes. By briefly pressing the TIMER button you can browse through the
timer programme P1<>, P1<>, P2<> and P2<>. Here is an example of a possible pre-setting.
P1<>-temp: 07:30 - 08:30
P1<>-temp: 08:30 - 17:00
P2<>-temp: 17:00 - 23:00
P2<>-temp: 23:00 - 07:30
The TIMER function works only when the pilot flame is on. If the TIMER mode is switched on, the temperature
control will be the same as in the AUTO position. You can switch off the TIMER mode with the  and 
buttons. The remote control will automatically switch to the MAN function.

MAN

When the display shows the MAN position you can manually turn the hearth higher  and lower  by using
the big buttons. When you press and hold the  button the hearth will go to its lowest position: the pilot flame.
When you keep these buttons pressed, you will see the 'transmit' symbol top left in the display. You will know
when the hearth has reached its highest or lowest position when the LED of the receiver starts blinking.

Maintenance

Small maintenance

You can clean the outside of the hearth with a damp cloth that doesn't give off fluff. Only clean the outside
when the hearth is cold. If some coffee is spilled on the unit when it is burning, turn the hearth off immediately.
When the hearth has cooled off completely, you can remove any stains with a damp cloth
!
Do not use any aggressive cleansing agents or abrasives and do not use stove polish.

Annual maintenance

Your gas hearth needs to be checked and maintained by a certified installer at least once a year. He will check
and, if necessary, clean the following components:
• The air-tightness of the exhaust pipes for gas and fumes and the pipes for supplying combustion air.
• The proper functioning of the gas governor, the thermocouple interrupter (a safety measure against un-
expected outflow of gas) and the ignition of the main burner.
• The entire pipe system, including the exterior wall or roof duct and the external terminal.
• Inspection of possible wear and tear of the sealing of the doors and glass panes.
• The following components will be cleaned: the main burner, the pilot light, the flue tube and the supply of
combustion air. Any dust collected in the hearth can be removed with a vacuum cleaner.
the pre-set temperature
off
the pre-set temperature
off
21