Télécharger Imprimer la page

Napoleon Tall Linear Vector Serie Manuel D'installation page 41

Publicité

Les langues disponibles

Les langues disponibles

6.4
battery holder/switch installation
6.5
initializing the battery holder/switch for the first time
note:
The initializing process must be completed within 10 seconds of pressing the reset / program (PRG).
Install the 4 AA batteries into the battery holder, note the polarity of the batteries and insert as indicated
A.
on the cover (+/-).
Ensure the 3 position slider switch is switched to the "REMOTE" position (middle position).
B.
Press the reset/programming button, use a small object such as a paper clip in order to reach the button
C.
marked PRG, as shown in the illustration below.
The battery holder will beep 3 times to indicate that it's ready to synchronize with the remote.
D.
Install the 3 AAA batteries into the remote, as shown in the photograph below, then press the ON button,
E.
The battery holder will beep 4 times to indicate that the remote's command is accepted.
Battery Holder
Slider Switch
Reset / Program
Button (PRG)
electrical information
Install the battery holder/switch into
a standard electrical switch box.
Determine an appropriate location and
install the electrical box.
note:
Ensure the 3 position slider switch is
in the "REMOTE" position (middle).
W415-4127 / B-0 / 03.25.24
EN
Remote
41

Publicité

loading