Maintenance; General Maintenance; Troubleshooting - Ryobi P2700 Manuel D'utilisation

WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
To avoid serious personal injury, always remove the
battery pack from the tool when cleaning or performing
any maintenance.
PROBLEM
Tines will not oscillate
Motor fails to start when switch
trigger is depressed
The tines stop oscillating

MAINTENANCE

TROUBLESHOOTING

POSSIBLE CAUSE
Tines are clogged by dirt and
debris.
Battery is not secure.
Battery is not charged.
The unit is overloaded.
For any questions about operating or maintaining your product,
Your product has been fully tested prior to shipment to ensure
your complete satisfaction.
9 — English

GENERAL MAINTENANCE

Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps, etc.
Tighten securely all fasteners and caps and do not operate
this product until all missing or damaged parts are replaced.
Please call 1-800-860-4050 or contact an authorized service
center for assistance.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal injury.
Remove the battery pack, then remove any
obstruction from the tines.
To secure the battery pack, make sure the latches
on each side of the battery pack snap into place.
Charge the battery pack according to the instructions
included with your model.
Release the switch trigger and raise the tines. Restart
the cultivator and slowly lower the tines back to their
original depth.
CALL US FIRST
call the Ryobi Help Line!
®
SOLUTION