Maintenance - Ryobi P2803 Manuel D'utilisation

Pulverisateur de produits chimiques de 18 v
Masquer les pouces Voir aussi pour P2803:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ADJUSTING THE SPRAY NOZZLE
See Figure 10.
The spray nozzle can be adjusted from a stream to a fan
spray.
 Remove the battery pack from the tool.
 Loosen the nozzle for a stream.
 Tighten the nozzle for a fan spray.
SPRAYING HOME-AND-GARDEN CHEMICALS
See Figures 11 - 12.
 Install the battery pack into the tool.
 Depress the ON/OFF button to start the motor.
 The sprayer may be operated with the handle resting in
the handle storage area as shown in figure 11, or you
may remove and hold the handle as shown in figure 12.
 Aim the sprayer nozzle directly at the plants or objects
you wish to spray.
NOTE: Make sure to stand far enough from the object
being sprayed to prevent the spray from splashing back
onto you.
 Depress the trigger to start the spray.
WARNING:
To avoid serious personal injury, always remove the bat-
tery pack from the tool when cleaning or performing any

maintenance.

WARNING:
Always wear eye protection with side shields or goggles
marked to comply with ANSI Z87.1. Failure to do so could
result in fluids entering your eyes resulting in possible
serious injury.
OPERATION
 Release the trigger to stop the spray.
 Always empty, clean, and drain the tank after every use
 Thoroughly clean the chemical sprayer before storing or
 When you are finished with the sprayer, thoroughly wash
OPERATING TIPS
 Never point the spray end of the wand at yourself or
 Avoid spraying on windy days. Spray can be accidentally
 Never spray in the direction of people or animals; always
 Especially in warmer weather, spray in the early morning
 Never smoke, eat, or drink while operating the sprayer.
MAINTENANCE
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
NOTICE:
Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or a quali-
fied service center for assistance.
10 — English
as directed in the Maintenance section.
before switching to a different chemical. See Cleaning
the Unit later in this manual.
your hands and any area where skin has been exposed
to the spray.
others.
blown onto plants or objects that should not be sprayed.
spray downwind.
or late afternoon. Excessive heat can evaporate the spray
before it settles.
WARNING:

Publicité

Table des Matières
loading

Table des Matières