Operation - Ryobi P2803 Manuel D'utilisation

WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
product when assembling parts.
CONNECTING THE SPRAY WAND TO THE
HANDLE
See Figure 2.
 Insert the spray wand into the the handle as shown.
 Slide the o-ring down until it touches the handle.
 Install the threaded coupler onto the handle and tighten
securely.
 Rotate the nozzle until it is aligned with the handle (pointing
down) and ready for use.
 Slide the nut onto the threaded coupler and tighten
securely.
 Pull on the spray wand to be certain it is properly secured.
 Place the assembled handle into the handle storage area.
ATTACHING THE HOSE
See Figures 3 - 4.
To attach the hose to the tank:
 Slide the nut on the hose away from the hose end.
 Insert the hose end into the hose connector as shown.
Make sure the connection is secure.
WARNING:
Do not allow familiarity with the product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields or goggles
marked to comply with ANSI Z87.1. Failure to do so could
result in fluids entering your eyes resulting in possible
serious injury.
ASSEMBLY
 Slide the nut over the opening and hose end. Hand tighten.
Do not overtighten.
To attach the hose to the handle:
The hose comes preassembled to the handle. If it becomes
loose, follow the instructions below.
 Install the threaded coupler onto the handle and tighten
securely.
 Slide the nut on the hose away from the hose end.
 Insert the hose end into the opening on the threaded
coupler. Make sure the connection is secure.
 Slide the nut over the hose and threaded coupler. Hand
tighten. Do not overtighten.
ATTACHING THE QUICK RELEASE SHOULDER
HARNESS
See Figure 5.
To prevent back and shoulder fatigue, always use the quick
release shoulder harness when operating this tool. If your
back or shoulders become sore, take a break and then adjust
the position of the harness.
 Squeeze and hold the latch on the spring clip.
 Place the spring clip onto the strap hanger and release
the latch.
 Repeat to secure second spring clip.
 Place the strap around your shoulder and adjust it to a
comfortable position.

OPERATION

Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
Use safety equipment. Protect your eyes, skin, and lungs
while mixing, filling, spraying, and cleaning. Failure to do
so may result in serious personal injury and damage to
property.
8 — English
WARNING:
WARNING: