Eurosystems MZP02 Mode D'emploi page 13

1. Persons who are not familiar with the operating manual, as well as children, adolescents under the age of 16 and persons under the influence
of alcohol, drugs or medication must not operate the mower.
2. The unit was designed in order to be used by 1 trained operator only. The person using the mower is responsible for any accidents involving
other persons or their property. When operating the machine, the user should ensure that no others, particularly children, are standing in the
area (10 mt.).
3. Work only in daylight or in good artificial light. Visibility is essential to guarantee safety conditions.
4. Before start to operate the unit, check carefully the feeding cable. In case the feeding cable shows to be damaged do not use the tiller:
verify first the damage , make up for it : do not put the plug into the socket.
5. The section of the mains cable must be the same or higher if compared to class 05 RN. The value of the mains supply current to which the
machine is to be connected must correspond to the data shown on the machine label. For safety reasons, a 10A circuit breaker and a nominal
10/30 mA automatic cut-out must be installed on the power line.
6. Rotavator tines assembly disassembly, cleaning, servicing operations must be performed when the engine is switched off and the plug
removed from the socket.
7. Start the cultivator standing behind the handlebars. The operator's position must be the same ( i.e. standing behind) at all times. Do not
work backwards, as there is risk of falling. Please walk, never run with the machine.
8. Do not touch/change safety/protection devices. If the operator releases the lever (Fig.4 - part.2), the motor/rotavator/tines must switch
off.
9. When the cultivator blades are in action, bear in mind the risk of injury to the feet: wear solid/suitable closed shoes and do not get near to
the cultivator blades.
10. Before starting the machine , check the area to be worked for foreign bodies and stones. Do not use the machine on ground containing
large stones.
11. In the case of an obstacle being hit which stops the machine, contact a service dealer to check it.
12. If the operator needs to lift up the blades from the ground for any reason, the machine must be switched off and the rotavator/tines must
be at a standstill. Do not leave the motor hoe unattended in the work area.
13. Do not store the motor hoe with plug inserted in the socket.
14. Do not use the motor hoe when it is raining, or in wet and damp weather. Do not sprinkle water on the machine and keep it protected from
humidity. Do not use the motor-hoe near ponds, swimming pool and water in general.
15. Modifications or make-shift repairs on the machine are absolutely forbidden.
16. Please note that our company assumes no responsibility for damages due to: a) repairs made by unspecialized/unauthorized after sales
service centres and/or (b) use of other than ORIGINAL SPARE PARTS. The same conditions apply to the accessories.
ASSEMBLY INSTRUCTIONS:
box packaging) is not completely assembled, please go on as follows :
HANDLEBARS ASSEMBLY (fig. 2- 2b) :
a) Insert the lower handle (3) into the two holes of the frame (11).
b) fix it with two screws (8), four washers (9) and two nuts (10).
if the machine is not completely assembled do the following steps: at the purchase of the unit ( inside the carton
EN
13