Bosch BDU280P Mode D'emploi page 92

EN-88
Assembly
A
(18)
(14)
(16)
(1) On-board computer
(5) Holder for on-board computer
(14) Drive unit contacts
(15) Locking screw for on-board computer
(16) Headset screw
(18) Magnet holder
Fitting and removing the on-board
computer (see figure A)
Fit the lower part of the Kiox into the holder (5) first
and tilt it forward gently until you can feel that the on-
board computer is firmly fixed in the magnetic holder.
Bosch eBike Systems
(1)
1
(5)
(15)
2
To remove the on-board computer, hold it by the top
end and pull it toward you until it disengages from the
magnetic holder.
When you park up the eBike, remove the on-
u
board computer.
The on-board computer can be secured in place to
prevent it from being removed from the holder. To do
this, loosen the headset screw (16) until the Kiox
holder can be swiveled sideways. Put the on-board
computer in the holder. Screw the locking screw (M3,
6 mm long) from below into the thread provided in
the on-board computer (using a longer screw may
damage the on-board computer). Swivel the holder
English – ​ 7
1 270 U20 XBK | (27.03.2019)