Abnormalities And Errors - B.A. International Powersurge LED Manuel D'utilisation

11. Abnormalities and errors

E
This section is intended to help users should a problem occur.
In the event of abnormal operation (screen that glistens, noisy pump motor, vibration in the micromotor), immediately stop using
the device and call your
description, or if the disfunction symbols remain active, switch off the device and call your
Under no circumstances try to dismantle the control unit, motor or control pedal for the
Never try to repair it alone.
Abnormality screen
Dysfunction
The screen does not come on.
approved repair center. If it is not possible to locate or eliminate the problem using this
B.A. INTERNATIONAL
Analysis of disfunction
The pedal is not detected.
w Check that the pedal is properly connected to the box and check
the status of the connector.
w Press on the screen to make the safety signal go away and to go back
to the previous or initial screen.
The motor is not connected.
w Check that the motor is properly connected to the box and check
the status of the connector.
w Press on the screen to make the safety signal go away and to go back
to the previous or initial screen.
During the calibration process, the loading module is not connected to the contra-angle.
w Connect the loading module and validate to restart the operation.
w Press on the screen to make the safety signal go away and go back
to the previous screen.
Excess speed of the motor detected.
w Press on the screen to make the safety signal go away and go back
to the working screen.
Causes
w The device is switched off.
w The fuses are burnt.
w The wall supply socket is defective.
w The supply cable is defective.
BA Powersurge
Premium
approved repair center.
B.A. INTERNATIONAL
Powersurge unit.
Solutions
w Check that the device is properly connected
to the supply and that the On/ Off button
is in position 1.
w Replace the fuses.
w Move the device.
w Replace the cable.
21