Technical Characteristics; Connection / Installation; Micromotor Connection/ Disconnection - B.A. International Powersurge LED Manuel D'utilisation

8
There are 2 versions of
w One version without light.
w One version with an integrated LED in the contra-angle (see section « 17- Relevant references » ).
This product's software is a « multi-user » and/or « multi-protocol of implant », i.e. it is designed so that several users can use
the same resources. We can create up to 10 users or protocols that can hold a maximum of 10 sequences.

Technical characteristics

w Input supply : from 100 to 240 V 50-60Hz.
w Absorbed power : 200 W.
w Operational mode : intermittent S3 10 % (1 min ON/ 9 min OFF).
w Fusibles Ø 5x20 T3,15AH 250 V.
w Motor regime : 300 to 40 000 rpm.
w Motor torque : 7 N.cm (80 N.cm max with a
w Pump : 5-wheel peristaltic.
w Flow : 120 mL/min maxi (with
w Motor : BF applied part.
w Coupling type :
w IP2x box .
w IPx8 pedal.
w Conditions of use : temperature: +10°C to +40°C/ Relative humidity: 15 to 80 %.
Units displayed and meanings.
N.cm = torque (Newton per centimeter).
Rpm = speed (Turns per minute).

4. Connection / Installation

E
One must be familiar with all the safety instructions before installing and using the device (see section « 2 – Safety » ).
4.1 Connection to a local
E
Only use the supply cable supplied by the manufacturer.
Grounding reliability can only be achieved when power supply is connected to an equivalent receptacle
marked « Hospital Only » or « Hospital Grade ».
Check that the supply voltage is the same as that shown on the control unit and that the supply switch is in the 0 position.

4.2 Micromotor connection/ Disconnection

Line up the red dot on the micromotor with the red dot on the connection on the front side of the panel and clip :
Powersurge units available :
Powersurge
B.A. INTERNATIONAL
specific Intramatic Lux compatible and « E » Type.
B.A. INTERNATIONAL
PS20X, L, LED - 20 :1 contra-angle).
irrigation lines).