Abicor Binzel WH Mode D'emploi page 42

6 Putting into operation
6.12 Manual torch neck change
Fig. 16 Manual torch neck change
6.13 Automatic torch neck change
EN - 18
4 This completes the introduction of the wire.
1.
2.
NOTE
• Do not change the hand lever position during the change procedure! This
will result in malfunctions. The open knife will cause the pre-tensioned
welding wire to expand and to become cut off when actuated next.
These wire pieces will block the locking mechanism and inevitably lead
to failures of the entire system!
1 Insert the hand lever through the sealing lips of the clamp clip into the bore.
2 Move the hand lever forwards in the direction of the torch neck past the
pressure point to the stop and take out the torch neck.
3 Insert the torch neck into the changeable body up to the stop.
4 Push the hand lever toward the rear up to the stop and take it out, after
locking it.
The ATS rotor torch change system is a peripheral device that performs the
torch neck change during the fully automatic welding process. Request order
documentation on this or consult special documents for the exact procedure.
WH and WHPP
4.
3.