Abicor Binzel WH Mode D'emploi page 41

WH and WHPP
1 Motor control
2 Push motor
3 Feed block
Fig. 15 Pull motor activation option
6.10 Setting the shielding gas quantity
6.11 Introducing the wire
6
M
7
8
4 Feed rollers
5
Micro-fuse
6 Pull motor
These three functions are activated via robot outputs on the input plug X10,
while the pull motor is connected via the plug X11. For further information, such
as connecting diagrams and specifications, please refer to the operating
instructions BAL.0067 Pull Motor Activation.
NOTE
• The type and quantity of the shielding gas quantity depends on the
welding task and the gas nozzle geometry.
• To prevent the shielding gas supply from becoming clogged by
impurities, the cylinder valve must be opened briefly, before connecting
the cylinder. This will blow out any impurities that may be present.
• Make all shielding gas connections gas-tight.
1 Connect shielding gas cylinder to the wire feeding system.
2 Set the gas quantity on the pressure reducer of the shielding gas cylinder.
1 Insert the wire in the wire feed unit as specified by the manufacturer.
NOTE
• The pressure force of the pressure roller has been factory pre-set. Do not
change the contact pressure by bending leaf spring, but only via the fine
adjustment, if required.
2 Open the housing cover at the changeable body WHPP, relieve the leaf
spring tension and swing out the pressure roller.
3 Press the "Currentless wire feed" pushbutton at the changeable body WH.
11
1
2
X11 X10
M
3
4
7
8
9
6 Putting into operation
Pull gearbox
Wire feed roller
Pull motor activation
EN - 17