Abicor Binzel WH Mode D'emploi page 36

6 Putting into operation
6.2 Equipping the ROBO WH 650 torch neck
1
1 Gas Nozzle
2 Welding spatter guard
Fig. 8 Equipping the ROBO WH 650 torch neck
6.3 Equipping the ROBO WH 652D (TS) /WH W500 torch neck
1
1 Gas Nozzle
2 Contact tip
Fig. 9 Equipping the ROBO WH 652D (TS)/WH W500 torch neck
6.4 Equipping the hose assembly
EN - 12
2 3 4
3 Contact tip
4 Tip adaptor
1 Screw the contact tip (3) into the tip adaptor (4) and tighten it using a
multiple wrench.
2 Screw the welding spatter guard (2) into the torch neck (5) .
3 Slide the gas nozzle (1) on the torch neck (5) rotating it slightly clockwise.
4 Screw in the ready-to-use equipment kit (6) on the connection side.
3
2
3 Tip adaptor
4 Welding spatter guard
1 Screw the tip adaptor (3) into the torch neck (5) .
2 Screw the contact tip (2) into the tip adaptor (3) and tighten it using a
multiple wrench.
3 Screw the welding spatter guard (4) into the torch neck (5).
4 Slide the gas nozzle (1) on the torch neck (5) rotating it slightly clockwise.
5 Screw in the ready-to-use equipment kit (6) on the connection side.
NOTE
• Select the proper wire type and the related wire guide.
• For cutting the wire size and for correct mounting, please observe the
following chapters:
 9 Maintenance and cleaning on page EN-20
5
5
6
5
4
5
6
WH and WHPP
6
Torch neck
Equipment kit
6
Torch neck
Equipment kit