Abicor Binzel WH Mode D'emploi page 37

WH and WHPP
6.5 Mounting the welding torch system on the robot
1
6
1 6 pan head screws M3x10
2 Changeable body
Fig. 10 Mounting the welding torch system on the robot
6.6 Mounting the machine side connection
NOTE
• Guide spiral liners = for steel and stainless steels
• PA liners = for aluminum, copper, nickel and stainless steels
1 Lay out the hose assembly straight.
2 Slide the ready-to-use wire guide from the central plug up to the stop in the
changeable body and screw it down by means of the spigot nut.
2
5
3 Robot
4 CAT torch holder
1 Mount the mounting bracket (6) at the changeable body (2) using the
enclosed six pan head screws (1) .
2 Mount the mounting bracket (6) to the CAT (3) ABICOR BINZEL torch
holder.
3 Drill a  6H7 bore in both mounting brackets (6) and pin them together
using the enclosed shoulder bolt (4).
For proper mounting of the CAT ABICOR BINZEL torch holder, please
observe the relevant operating instructions.
Check once again whether the wire guide has been fastened correctly.
1 Join the central plug and the central socket at the wire feed unit and secure
them with a connection nut.
4
5
6
6 Putting into operation
3
Shoulder bolt
Mounting bracket
EN - 13