Publicité
Les langues disponibles
Les langues disponibles
.
.
.
SAFETY AND MAINTENANCE 1NSTRUCTIONS
• The operator must be trained for workíng with the
machine on which the numerical control is installed.
• lmproper use of the numerícal control can cause
heavy damage on equípment and/or injuríes to
people.
• Modífícatíon of machine parameters can cause
important material damage or lead to irregular
product qualíty.
• The rear panel may only be removed by a qualified
technícían (danger of electrocutíon).
• Do not expose the numerícal control to excessíve
humidíty so as to avoíd any rísk of electrocutíon and
any deteríoration of the equípment.
• Make sure the numerícal control ís disconnected
from the maíns power before carrying out any
cleaning. Do not use líquids based on alcohol or
ammoniac.
• 1n case of malfunction of the numerícal control, ca11 a
technician.
• Do not expose the numerícal control to direct sun
rays or any other heat source.
• Do not place the numerícal control in the
neíghbourhood of magnetíc equipment such as
transformers, motors or devices which generate
ínterference (weldíng machines, etc.)
•
Replace fan filters at regular íntervals so as to avoíd
overheatíng.
SAFETY AND MAINTENANCE INSTRUCTIONS
PAGE I
Publicité
