Steam Ironing; Ironing With Steam Blast - SilverCrest SDB 2400 F4 Mode D'emploi

Temperature control
3) Select the appropriate temperature setting with the temperature control 8 .
NOTE
► Always place the iron on the base 0 while it heats up . If you place the
iron on the sole of the iron q and do not move it, the automatic switch-off
will be activated after 30 seconds (see section Automatic switch-off)
and the appliance stops heating up .
■ The temperature control lamp 7 lights up . When the set temperature has been
reached, the temperature control lamp 7 goes out .
4) Wait until the temperature control lamp 7 goes out .
■ To moisten the laundry, press the spray button
■ This function is suitable for very dry and very crumpled garments .

Steam ironing

1) Set the steam control 3 to the desired steam setting .
2) The temperature control 8 must be set to at least the
Otherwise no steam will be produced .

Ironing with steam blast

■ The steam blast function is especially suitable for smoothing difficult-to-reach
parts of a garment .
1) Raise the steam iron slightly .
2) For a steam blast, press the steam blast button
steam blast function to smooth hanging textiles .
3)
■ 22 │ GB │ IE
symbol 8
Hold the iron vertically and press the steam blast button
material type
Acrylic, rayon
Silk, wool, polyester mix fabrics
Cotton, linen, viscose
5 .
setting .
4 . You can also use the
4 .
SDB 2400 F4