Spray Function; Ironing Without Steam; Ironing With Steam; Steam Burst Function - SilverCrest SDBK 2400 C2 Mode D'emploi

__RP37102_Dampfbügeleisen_B3.book Seite 9 Montag, 2. September 2013 8:00 20

7.3 Spray function

Use the spray function in order to dampen
dry items of laundry. This option is available
irrespective of the set temperature. For this
purpose, the water tank 17 must be at least
one quarter full.
• Press the spray button 4
While doing so, hold the steam iron
over the item of laundry. Ensure that no
water sprays onto the ground.

7.4 Ironing without steam

Sensitive fabrics are ironed at lower temper-
atures and without steam. In order to damp-
en them, the spray function is available.
1. Set the steam flow rate control 3 to
and set the temperature controller 20 to
MIN.
2. Fill the water tank 17 if you wish to use
the spray function.
3. Place the steam iron in the stand 13.
4. Connect the mains plug with the wall
socket.
5. Set the desired temperature using the
temperature controller 20. The tempera-
ture control lamp 15 lights up.
6. Start ironing as soon as the ironing tem-
perature has been reached 15 and the
temperature control lamp goes out.
7. Finish ironing, set the temperature con-
troller 20 to MIN and pull out the
mains plug.
8. Allow the steam iron to cool down, and
pour off any remaining water from the
water tank 17 through the filling open-
ing in the water tank (under the lid 2).

7.5 Ironing with steam

Steam ironing requires a high temperature,
at least the temperature setting for
der to additionally dampen items of cloth-
ing, the spray function is also available.
1. Set the steam flow rate control 3 to
and set the temperature controller 20 to
MIN.
2. Fill the water tank 17.
3. Place the steam iron in the stand 13.
4. Connect the mains plug with the wall
socket
repeatedly.
5. Set the temperature controller 20 to the
desired temperature (at least
temperature control lamp 15 lights up.
6. As soon as the ironing temperature has
been reached and the temperature con-
trol lamp 15 goes out, adjust the steam
flow rate controller 3 to the desired
steam flow rate
ironing.
The steam will...
... start to come out as soon as you hold
the steam iron horizontal, and
... stop as soon as:
- you hold the steam iron vertical,
- you place the steam iron in the stand
13,
- the temperature falls too low,
- the water tank is empty,
or
- you set the steam flow rate controller
3 to
7. Finish ironing, set the temperature con-
troller 20 to MIN, set the steam flow
rate controller 3 to
mains plug.
8. Allow the steam iron to cool down, and
pour off any remaining water from the
water tank 17 through the filling open-
ing in the water tank (under the lid 2).

7.6 Steam burst function

The steam burst function requires a high tem-
perature. Select a temperature setting be-
tween
. In or-
water tank 17 must be at least one quarter
full.
and start
.
and pull out the
and MAX. For this purpose, the
GB
). The
9