Operating Elements; Before First Use - SilverCrest SDB 2400 F4 Mode D'emploi

operating elements

Figure A:
1 Water jet
2 Filler opening for the water tank
3 Steam control
4 Steam blast button
5 Spray button
6 Control lamp for the automatic switch-off
7 Temperature control lamp
8 Temperature regulator
9 Power cable with anti-kink protection
0 Base
q Sole of the iron
w Self-clean button
Figure B:
e Measuring beaker

Before first use

1) Remove the steam iron from the packaging .
2) Remove all stickers and protective films from the steam iron and from sole of
the iron q .
RISK oF SuFFocATIon!
► Plastic bags may pose a risk . To avoid the risks of asphyxiation, keep
plastic bags out of the reach of toddlers and small children .
3) Fill the water tank with water (See the section Filling the water tank) .
4) Insert the plug into a mains power socket supplying an electrical current as
detailed on the rating plate .
5) Move the temperature control 8 to the "MAX" position .
6) Heat the steam iron up for several minutes at the highest setting .
7) Activate the steam blast button
out of the sole of the iron q .
8) Then iron over a piece of old piece of material to remove any residues that
may remain on the sole of the iron q .
■ 20 │ GB │ IE
4 a couple of times so that steam comes
SDB 2400 F4