Plugging In And Ironing; Steam Ironing; Ironing With Steam Blast; Putting The Steam Iron Down - SilverCrest SDBE 2600 A1 Mode D'emploi

Plugging in and ironing

Dry ironing without steam is possible at all tempera-
tures, steam ironing is only possible from the setting
on the temperature control 6.
range
■ Insert the plug into a mains power socket.
CAUTION! PROPERTY DAMAGE!
► If the clothing care instructions forbid ironing,
( symbol), the clothing item may not be
ironed. Ignoring this warning could lead to
permanent damage to the clothing item.
■ Check the care instructions on the labels in
garments to see if they are suitable for being
ironed, and at which temperature setting.
Temperature
control
icon 6
■ Select the appropriate temperature setting using
the temperature control 6.
NOTE
While it is heating up, always place the iron on
the base 9.
If you place the iron down on its sole 0 and do
not move it, the automatic switch-off will be acti-
vated after 30 seconds (see chapter "Automatic
switch-off ") and the appliance stops heating.
SDBE 2600 A1
All manuals and user guides at all-guides.com
Type of Material
Acrylic, rayon
Silk, wool,
polyester mix fabrics
Cotton, linen,
viscose
The temperature control lamp 7 lights up. When
the control lamp 7 goes out, the set temperature
has been reached.
Wait until the temperature control lamp 7
■
goes out.
■ To moisten the laundry, press the spray
4.
button
This function is suitable for very dry and very
crumpled garments.

Steam ironing

Set the steam control 3 to the desired steam
■
setting.
The temperature control 6 must be set to at
■
least the setting . Otherwise no steam can
be produced.

Ironing with steam blast

The steam blast function is especially suitable for
smoothing diffi cult-to-reach parts of a garment.
■ Raise the steam iron slightly.
■ For a steam blast, press the steam blast
5.
button

Putting the steam iron down

RISK OF FIRE!

► Never leave a hot steam iron unattended if
it is switched on or connected to the mains
power supply.
Move the temperature control 6 to the "MIN"
■
position.
Stand the steam iron only on the base 9.
■
GB
27