Filling The Water Tank; Plugging In And Ironing - SilverCrest SDB 2400 F4 Mode D'emploi

Filling the water tank

1) Hold the iron in your hand at an angle.
2) Open the cover of the filler opening for the water tank 2.
3) Using the measuring beaker e, fill the water tank with water to the "MAX"
marking, but no further.
4) Close the cover of the filler opening for the water tank 2.
NOTE
► If the mains water in your location is rated as hard, we recommend that
you mix the mains water with some distilled water. Otherwise, the jets for
the steam blast function could become blocked with limescale prematurely.
To extend the optimal steam blast function, mix mains water with distilled
water according to the table.
Water hardness
The water hardness level can be queried at your local water works.

Plugging in and ironing

Dry ironing without steam is possible at all temperatures, steam ironing is only
possible from the setting range
1) Insert the plug into a mains power socket.
CAUTION! PROPERTY DAMAGE!
► If the clothing care instructions forbid ironing (
be ironed. Ignoring this warning could lead to permanent damage to the
clothing item.
SDB 2400 F4
very soft/soft
medium
hard
very hard
Ratio of distilled water to tap water
0
1: 1
2: 1
3: 1
on the temperature regulator 8.
), the garment must not
GB │ IE │
7 ■