Filling The Water Tank - SilverCrest SDBS 2200 A1 Mode D'emploi

Filling the water tank

GB
IE
12
NOTE
Use only tap water or distilled water.
If the tap water in your locality is rated as hard, it is a good idea to mix the
tap water with some distilled water. Otherwise, lime scale build-up could
impair the functionality of the appliance.
Mix the tap water with distilled water as described in the table below:
Water hardness
very soft/soft
medium
hard
very hard
Water with additives (such as starch, perfume, conditioner or other chemicals)
may not be put into the water tank
as residues can form in the steam chamber. The residues could contaminate
clothing if they come out of the steam outlets.
♦ Reach into the recess on the water tank
upwards with your fi ngertips.
♦ Pull the water tank
♦ Fill the tank only up to the maximum limit.
♦ Push the water tank
If necessary, press a little harder on the upper part of the water tank
ensure that it has clicked into place and is securely connected to the base
station .
NOTE
► Do not tip or swing the steam station when it has a full water tank
Otherwise the water may spill out of the fi lling hole.
► Fill the water tank
empty" indicator
Ratio of distilled water to
. These could damage the appliance
and press the release catch
forwards and out.
back onto the base station
before fi rst use and as soon as the "Water tank
lights up.
mains water
0
1:1
2:1
3:1
until it clicks into place.
SDBS 2200 A1
to
.