Returning To The Original Factory Setting; Recommendations On Use; Frost Warning - Atlantic 2012 Série Notice D'utilisation Et D'installation

Another example :The wheel D is set to 21°C.The temperature
displayed on your thermometer is 18°C.The calibration value will
therefore be -3°C (3 notches).
If you wish to set your device to
to the end stop. But if you align the pictogram
, you will obtain a temperature of 15°C.
If your calibration value is +3°C, the wheel's end stop will be on 15°C, but you will still have a Frost-free tem-
perature of 7°C.
r
eTUrning To The originaL FaCTory SeTTing
Your device provides you with the possibility of returning to the original factory setting.
Turn the temperature-setting wheel d up to the end stop (anti-clockwise).
Pull the wheel's outer ring d while holding in the central part.
Set the outer ring to align the mark
Then push the wheel's outer ring back to its initial position.
- It is useless to set the device to maximum power, the bathroom temperature will not rise any fas-
ter.
- If you will be away for more than 48 hours : set the mode selection wheel a to on and the tem-
perature setting wheel d to
Your device will keep the temperature at 7°C (±3° C).
Your device is equipped with a function to alert you when your room temperature is below
3°C. In this case the red light B flashes.
We recommend that you put your device in
, you must turn the wheel up
with the pictogram
r
eCommendaTionS oF USe
.
F
roST Warning
with the mark
.
mode to avoid any risk of damage to your room.
23
gB