Publicité
Les langues disponibles
Les langues disponibles
• Use protective gloves and do not touch the saw
blade with your bare hands.
13. Cleaning
m DANGER
Risk of electric shock due to water entering into the
machine.
- Do not splash the product with water.
m WARNING
Danger of injury due to unexpected start-up of the
machine
- Remove the mains plug from the socket.
13.1 Cleaning the product and saw blade guard
ATTENTION
Product damage due to insufficient cleaning
- Clean the product thoroughly after each use.
ATTENTION
Product damage due to aggressive solvents or clean-
ing agents.
- Use a brush to remove course dirt.
- Clean the product with a damp, clean, lint-free
cloth and soft soap.
1. Remove dust and chips with a brush after each
working operation.
2. Clean the ventilation holes with a lint-free cloth.
13.2 Clean the product with compressed air
ATTENTION
Product damage due to use of a compressed air de-
vice with too high of a pressure
By cleaning the product with highly compressed air,
electrical components may become damaged.
- Use a compressed air device with a low pres-
sure of max. 2 bar.
1. Always keep enough distance to the product.
2. Remove dirt with a compressed air device (max.
2 bar).
13.3 Cleaning the chip extraction system
A chip extraction system is not included in the scope
of delivery. Follow the manufacturer's operating in-
structions to properly clean the extraction system.
14. Transport
m WARNING
Danger of injury due to unexpected start-up of the
machine
- Remove the mains plug from the socket.
14.1 General notes
• Only lift the product by the machine housing.
42 | GB
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
• Package the product to prevent transport damage.
Use the original packaging.
• Protect the product from vibrations and shocks, in
particular during vehicular transport.
• Ensure adequate load securing when transporting
in a vehicle.
14.2 Product-specific notes
m WARNING
Danger of injury due to excessive product weight.
- Ask a second person to help you mounting the
product.
1. When lifting the product, note its weight see tech-
nical data.
2. Always switch off the electrical tool before trans-
port and disconnect it from the power supply.
3. Always carry the power tool with at least one oth-
er person, do not carry by the table extensions.
To transport the power tool, lift it by the machine
housing.
4. Protect the power tool from impacts, shocks and
severe vibrations, e.g. during vehicular transport.
5. Secure the electric tool against toppling and slip-
ping.
6. Never use protective devices for handling or
transport.
14.3 Transporting the device using the machine
stand (fig. 37)
• Lift the device by the machine stand as shown in
fig. 37.
• Move the device to the desired location.
14.4 Folding the machine stand in and out (fig. 37)
• To fold in the machine stand (24), release the lock-
ing latch (14) and fold in the machine stand (24).
• To fold out the machine stand (24), lift the machine
and ensure that the locking latch (14) engages.
15. Maintenance
m WARNING
Danger of injury due to unexpected start-up of the
machine
- Remove the mains plug from the socket.
m WARNING
Warning against unexpected hazards and damages
to the product
- Never carry out unauthorized changes or repairs
to the product that are not described in the oper-
ating manual.
- Do not carry out work on the product described
for a specialist workshop.
15.1 General notes
• Check the product for loose, worn or damaged
components.
Publicité
