Check On Operation Of Relays - Burkert 8025 Notice D'utilisation

4 CONFIGURATION
« EXT. [T] Option
In this option, the user can check the pulse duration being sent to the dose controller.
ENTER
EXT.ACT.
ENTER
RELAY 1

4.5.2. Check on operation of relays

This option allows the operator to check for correct operation of the relays by using the
keypad to energise the relays.
ENTER
RELAY 1
ENTER
RELAY 2
FREQUENC
4.5.3. Frequency readout
Readout of vane rotation frequency. To clear the display and proceed to the next option,
press on the Enter key.
ENTER
FREQUENC
ENTER
END
Note: After the display of the « FREQUENC » prompt, pressing on the Enter key will
energise Relay 1 (to open the valve).
BATCH CONTROLLER 8025
0.00 SEC
Start of pulse
REL OFF
ENTER
REL ON
REL OFF
ENTER
REL ON
15.25 HZ
E-32-
. . . . SEC 5.35 SEC
End of pulse
8025-BATCH-**