Installing The Intenza+ Water Filter; Replacing The Intenza+ Water Filter - Gaggia Milano CADORNA PRESTIGE Mode D'emploi

English
16
Filter expired, replace
or disable it
ON/OFF my favourites HOME clean/setting
WATER FILTER
REPLACE
ACTIVATE
DISABLE
ON/OFF my favourites HOME
4219-450-08061 MANUAL GAG. CAD. PRESTIGE EN-FR 120US.indd 16

Installing the INTENZA+ water filter

Remove the small white filter from the water tank and store it in a dry place.
Immerse the INTENZA+ water filter vertically (with the opening pointing up) in cold
water and gently press its sides to let any air bubbles out.
Remove the INTENZA+ water filter from the water. Set the machine according to
the detected water hardness (see the "Measuring water hardness" chapter) and the
letters found on the filter base:
A = soft water – 1 or 2 small squares
B = hard water (standard) – 3 small squares
C = very hard water – 4 small squares
Place the INTENZA+ filter in the water tank, ensuring it is correctly in place. Refill
the water tank and place it in its compartment.
Follow the instructions shown on the display to activate the filter.
Note: you can pause the filter activation procedure by pressing the START/STOP
button. To resume the procedure, press the START/STOP
START/STOP

Replacing the INTENZA+ water filter

When the INTENZA+ water filter runs out, the display will show a warning
message.
1 Replace or disable by pressing the CLEAN/SETTING
" SETTINGS " button.
2 Select the " WATER FILTER " button.
START/STOP
3 Select " REPLACE " to change the filter or " DISABLE " if you do not intend to
use the filter. Confirm with the "
Follow the instructions shown on the display to activate the filter correctly.
Note: If you do not want to replace the filter, select "DISABLE" to disable it.
clean/setting START/STOP
START/STOP
button, and then the
clean/setting
" button.
button again.
08/11/2019 13:01:04