Water Connection - Gaggia EVOLUTION E90 Mode D'emploi Et D'entretien

Before proceeding with installation check that:
• there are no bumps, signs of knocks or deformities.
• there are no damp patches or marks which could lead one
to assume that the packaging has been exposed to the
elements
• there are no signs of tampering
Once one is satisfied that transportation has been
correctly effected proceed with installation.
Make sure the machine is
installed on a flat surface
capable of
weight (see
Specifications"
and take care of leaving a
clear area of at least 30 cm
around the machine.
The least height of the
support's top must be
110cm (The higher surface
of the appliance
however be at least 1,5 m
from the ground level).
the maximum
inclination of the supporting
surface must NOT exceed 2°.
Proceed with installation following the instructions according to the
sequence as described below.
5.1
bearing its
"Technical
chapter)
shall
angle of
Connect purifier (F) to the water mains (A).

Water connection

Before connecting
appliance to water network,
please read and follow the
applicable regulations in force
in your country.
Water hardness should not
be less than 8°F.
We recommend that the
machine be supplied with
water treated by a descaling
device, particularly for water
with high content of calcium
and magnesium (hard water).
Make sure the water network
provides drinkable water, with
pressure ranging between
0,15MPA - =,8MPA (1,5 and
8 bars).
English
the
51