Kärcher RCF 3 Mode D'emploi page 19

Special modes
Sleep mode
The cleaning robot automatically switches to sleep
mode after 5 minutes of inactivity. Press any button to
wake it up.
● The cleaning robot does not switch to sleep mode
when it is on the charging station.
● The cleaning robot switches off automatically if it is
in sleep mode for more than 6 hours
"Do not disturb" mode
It is possible to activate the "Do not disturb" mode. In
"Do not disturb" mode, the cleaning robot does not re-
sume an interrupted cleaning, does not perform sched-
uled cleaning and does not give audible warnings. The
LED display indicators are switched off.
"Do not disturb" mode can be activated in the App.
Downloading the app is described in the chapter Con-
necting cleaning robots with WLAN and App.
Note
In "Do not disturb" mode, the cleaning robot is not
switched off. To continue cleaning, briefly press On/Off/
Pause button.
Remote control
In the app, there is the option to navigate the robot if it
gets stuck in an inaccessible place, for example.
This remote control can be selected in the app under
"Settings" > "Robot settings".
Initial start-up
Setting up the charging station
WARNING
TheRCF 3 cleaning robot may only be charged on the
charger of a charging station with the part number
4.269-072.0.
● Select the location so that the cleaning robot can
easily reach the charging station.
Note
Position the charging station on a floor that is not sensi-
tive to water, as the damp roller could affect the floor
during charging.
● Ensure a distance of at least 0.5 m to the left and
right of the charging station and a distance of at
least 1.5 m in front of the charging station.
● The location must not be exposed to direct sunlight.
1. Set up the charging station.
Illustration B
2. Peel off the film on the adhesive strip of the cable at-
tachment and attach the cable attachment to the
back of the charging station. Place the cable neatly
as required.
Illustration D
3. Plug the mains cable device plug into the cable
holder on the side of the charging station.
Illustration C
4. Connect the mains plug.
Connecting the cleaning robot with the
charging station
1. Place the cleaning robot manually on the charging
station and make sure that the battery terminals
have a good contact.
The cleaning robot switches on automatically and
emits an acoustic signal. The LED display indicators
light up.
Note
During the initial start-up, manual switch-on without
contact to the charging station is not possible.
After the initial start-up, the cleaning robot automatically
moves to the charging station.
Connecting cleaning robots with WLAN and
The cleaning robot can be controlled directly via buttons
on the device or via an App using a WLAN-enabled mo-
bile device. To be able to use all available functions we
recommended controlling the cleaning robot via the
Kärcher Home Robots App.
Before you download the App, make sure you have the
following:
● The mobile device is connected to the Internet.
● The 2.4 GHz WLAN of the router is activated.
● Sufficient WLAN coverage is guaranteed.
Download the Kärcher Home Robots App from the Ap-
®
ple App Store or from Google Play™ store.
● Google Play™ and Android™ are trademarks or
registered trademarks of Google Inc.
®
● Apple and the App Store
tered trademarks of Apple Inc.
Connecting the cleaning robot with the Kärcher
Home Robots App and WLAN:
1. Download the KÄRCHER Home&Garden App from
the Apple App Store or from the Google Play Store.
2. Open the Kärcher Home Robots App.
3. Create an account (if you are not already regis-
tered).
4. Add the desired cleaning robot.
5. Follow the step-by-step instructions in the App.
Inserting the waste and fresh water tank
The waste water tank must first be inserted into the
fresh water tank before the entire tank module can be
installed in the cleaning robot.
1. Push the waste water tank horizontally into the fresh
water tank until it audibly latches into place.
Illustration F
2. Push the fresh water tank horizontally into the clean-
ing robot until it audibly latches into place.
Illustration G
Note
It is also possible to insert the fresh water tank into the
device first and then the waste water tank into the fresh
water tank.
English
App
®
are trademarks or regis-
Startup
19