Publicité
Les langues disponibles
Les langues disponibles
16. INSTALLING THE FLAME BROILER COMPONENTS
Parts Required:
1
x
Flame Broiler Adjusting Bar Handle (#6)
1
x
Flame Broiler Adjusting Bar (#7)
1
x
Flame Broiler Slider (#8)
1
x
Flame Broiler Main Plate (#9)
1
x
Smoker Adjusting Bar (#22)
Installation:
•
Insert the Flame Broiler Main Plate into the Main Barrel, right side
first. Rest the Flame Broiler Main Plate on the built-in ledge (on the
inside right) of the Main Barrel that directs grease towards the grease
bucket. Slide the entire piece to the left side, and the two slots on the
flame broiler main plate will fit into the rounded ledge above the fire
pot. It will sit slightly at a downward angle. Note 16A.
IMPORTANT: If the Flame Broiler Main Plate is on the base of the
barrel, it is installed incorrectly. The Flame Broiler Main Plate should
sit at an angle, with the left side sitting higher than the right. Poor
installation of this part may result in damage to your grill barrel.
•
Place the Flame Broiler Slider on top of the Flame Broiler Main Plate,
covering the slotted openings. Ensure the raised tab is on the left,
to easily adjust for direct or indirect flame when cooking. Note
illustration 16B. Both flame broiler parts are lightly coated with oil to
avoid rusting when shipped.
•
Next, remove the Flame Broiler Adjusting Bar Handle from the Flame
Broiler Adjusting Bar. Insert the Flame Broiler Adjusting Bar through
the opening hole on the left side of the main barrel. Add the Flame
Broiler Adjusting Bar Handle back onto the end outside the barrel.
Next, slide the notched end of the adjusting bar into the locking tab
on the Flame Broiler Slider, giving you adjustable access to the Flame
Broiler Slider on the main plate. Note steps in 16C.
NOTE: When the Flame Broiler Slider is open and direct flame is used,
do not leave the grill unattended for any period of time.
•
Install the Smoke Adjusting Bar in-between the two Main Barrels by
screwing it into the mount hole. Once installed, it should slide from
front to back smoothly. Note illustration 16D.
17. PLACING THE HEAT TENTS
Parts Required:
3
x
Heat Tents (#10)
Installation:
•
Place the three Heat Tents on the top of the burners in the Main Barrel.
The Heat Tents will lock into place over the knotches.
16A
9
16B
16C
7
6
16D
17
10
10
10
8
9
15
Publicité
