Standard Accessories; Applications; Battery Removal/Installation - Hitachi DV 14DCL2 Mode D'emploi

English
SPECIFICATIONS
POWER TOOL
Model
No-load speed (Low/High)
No-load impact rate (Low/High)
Brick
(Depth 30 mm)
Wood
Drilling
(Thickness 18 mm)
Capacity Metal
(Thickness 1.6 mm)
Machine screw
Driving
Wood screw
Rechargeable battery
Weight
CHARGER
Model
Charging voltage
Weight

STANDARD ACCESSORIES

In addition to the main unit (1), the package contains the
accessories listed in the table below.
1 Plus driver bit (No. 2 × 65L) .................... 1
DV14DCL2
2 Charger .................................................. 1
DV18DCL2
3 Plastic case ............................................ 1
Standard accessories are subject to change without notice.
OPTIONAL ACCESSORIES (sold separately)
1. Battery (BCL1415)
(For DV14DCL2)
2. Battery (BCL1815 or EBM1830)
(For DV18DCL2)
Optional accessories are subject to change without notice.

APPLICATIONS

○ Drilling of brick and concrete block, etc.
○ Driving and removing of machine screws, wood screws,
tapping screws, etc.
○ Drilling of various metals.
○ Drilling of various woods.

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latch (2 pcs.)
to remove the battery (see Figs. 1 and 2).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
10
DV14DCL2
0 – 400 / 0 – 1500 min
0 – 5600 / 0 – 21000 min
13 mm
32 mm
13 mm
6 mm
8 mm (diameter) × 50 mm (length)
(Requires a pilot hole)
BCL1415: Li-ion 14.4 V (1.5 Ah 4 cells)
1.5 kg
UC18YKL
7.2 – 18 V
0.4 kg
-1
0 – 5600 / 0 – 21000 min
-1
8 mm (diameter) × 75 mm (length)
BCL1815: Li-ion 18 V
(1.5 Ah 5 cells)
1.6 kg
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger's power cord to the receptacle.
When connecting the
a receptacle, the pilot lamp will blink in red
(At 1-second intervals).
2. Insert the battery into the charger.
Firmly insert the battery into the charger till it contacts
the bottom of the charger and checking the polarities as
shown in Fig. 3.
CAUTION
If the batteries are inserted in the reverse direction, not
only recharging will become impossible, but it may also
cause problems in the charger such as a deformed
recharging terminal.
3. Charging
When inserting a battery in the charger, the pilot lamp will
light up continuously in red.
When the battery becomes fully recharged, the
pilot lamp will blink in red (At 1-second intervals).
(See Table 1)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 1, according to the condition of the charger or the
rechargeable battery.
DV18DCL2
0 – 400 / 0 – 1500 min
-1
-1
13 mm
38 mm
13 mm
6 mm
(Requires a pilot hole)
EBM1830: Li-ion 18 V
(3.0 Ah 10 cells)
1.9 kg
plug of the charger to