Benelli 502C Mode D'emploi page 165

Periodic maintenance and adjustment
Replacing the fuses
The fuse boxes and individual fuses are lo-
cated under the passenger seat.
To access fuse box and the main fuse re-
move the passenger seat. (See page 3-14).
EN
6
If a fuse is blown, replace it as follows.
1. Turn the key to " " and turn o the
electrical circuit in question.
2. Remove the blown fuse, and then install
a new fuse of the speci ed amperage.
WARNING
Do not use a fuse of a higher amperage
rating than recommended to avoid cau-
sing extensive damage to the electrical
system and possibly a re.
Without Headlight Switch
15A 15A
10A
3. Turn the key to " " and turn on the
electrical circuit in question to check if the
device operates.
4. If the fuse immediately blows again,
have a Benelli dealer check the electrical
system.
6 - 30