Benelli 502C Mode D'emploi page 154

the clutch screw anticlockwise (seen from
sitting on the bike).
3) After adjusting, tighten the clutch ring
nut.
2
1
1. Clutch ring nut
2. Clutch screw
TIP
If the speci ed free play cannot be obtai-
ned as described above or if the clutch
does not operate correctly, have a Benelli
dealer check the internal clutch mechani-
sm.
Checking the brake lever free play
There should be no free play at the brake
lever end. If there is free play, have a Be-
nelli dealer inspect the brake system.
WARNING
A soft or spongy feeling in the brake
lever can indicate the presence of air
in the hydraulic system. If there is air in
the hydraulic system, have a Benelli de-
aler bleed the system before operating
the vehicle. Air in the hydraulic system
will diminish the braking performance,
which may result in loss of control and
an accident.
6 - 19
Periodic maintenance and adjustment
Brake light switches
The brake light, which is activated by the
brake pedal and brake lever, should come
on just before braking takes e ect.
If necessary, have a Benelli dealer adjust
the brake light switches.
EN
6