Panasonic EY7542 Instructions D'utilisation page 6

a. pins on plug of extension cord are
the same number, size and shape
as those of plug on charger.
b. extension cord is properly wired
and in good electrical condition.
c. wire size is large enough for ampere
rating of charger as specified below.
RECOMMENDED MINIMUM AWG SIZE OF
EXTENSION CORDS FOR
BATTERY CHARGERS
AC Input Rating. Amperes
Equal to or But less
greater than than
0 
8) Do not operate charger with damaged
cord or plug-replace them immediately.
9) Do not operate charger if it has receiv-
ed a sharp blow, been dropped, or
otherwise damaged in any way; take it
to a qualified service personnel.
10) Do not disassemble charger; take it
to a qualified service personnel when
service or repair is required. Incorrect
reassembly may result in a risk of
electric shock or fire.
11) To reduce the risk of electric shock,
unplug charger from outlet before
attempting any maintenance or clean-
ing.
1) The charger and battery pack are
specifically designed to work together.
Do not attempt to charge any other
cordless tool or battery pack with this
charger.
13) Do not attempt to charge the battery
pack with any other charger.
14) Do not attempt to disassemble the
battery pack housing.
15) Do not store the tool and battery pack
in locations where the temperature
may reach or exceed 50°C (1°F)
(such as a metal tool shed, or a car
in the summer), which can lead to
deterioration of the storage battery.
16) Do not charge battery pack when the
temperature is BELOW 0°C (3°F)
or ABOVE 40°C (104°F). This is very
important in order to maintain optimal
condition of the battery pack.
17) Do not incinerate the battery pack. It
can explode in a fire.
AWG Size of Cord
Length of Cord,
Feet
5 50 100 150
18 18 18 16
- 6 -
18) Avoid dangerous environment. Do not
use charger in damp or wet locations.
19) The charger is designed to operate
on standard household electrical
power only. Do not attempt to use it
on any other voltage!
0) Do not abuse cord. Never carry charger
by cord or yank it to disconnect from
outlet. Keep cord away from heat, oil
and sharp edges.
1) Charge the battery pack in a well ven-
tilated place, do not cover the charger
and battery pack with a cloth, etc., while
charging.
) Use of an attachment not recommend-
ed may result in a risk of fire, electric
shock, or personal injury.
3) Do not short the battery pack. A
battery short can cause a large current
flow, over heating and create the risk
of fire or personal injury.
4) NOTE: If the supply cord of this appli-
ance is damaged, it must only be
replaced by a repair shop authorized
by the manufacturer, because special
purpose tools are required.
5) TO REDUCE THE RISK OF ELEC-
TRIC SHOCK, THIS APPLIANCE HAS
A POLARIZED PLUG (ONE BLADE IS
WIDER THAN THE OTHER).
This plug will fit in a polarized outlet
only one way. If the plug does not fit
fully in the outlet, reverse the plug. If
it still does not fit, contact a qualified
electrician to install the proper outlet.
Do not change the plug in any way.
V
. ASSEMBLY
Attaching or Removing Bit
NOTE:
• When attaching or removing a bit,
disconnect battery pack from tool or
place the switch in the center position
(switch lock).
1. Hold the collar of quick connect chuck
and pull it out from the driver.
. Insert the bit into the chuck. Release
the collar.
3. The collar will return to its original
position when it is released.