BIONIME Rightest GM550 Mode D'emploi page 22

Recalling Test Result and Average
TM
The Rightest GM550 Meter is able to store 500 test results with time and date automatically. If your
meter has stored 500 results, which is the maximum memory of the meter, the newest test result will
replace the oldest one. To recall your test memory, start the meter without test strip inserted.
1. Press the main button to switch from the time mode to the Memory screen. First
you will see the "MEM" symbol on the up per left corner of the display. When you
press the right button, the latest result will be displayed. By pressing the right
button sequentially former test results will be shown in historical order.You will see
the sequence number on the lower right corner and the year on the lower left
corner of the display followed by date and time of the measurement.
Note: The right button is for reviewing the tests with sequence number increasing, and the left
button is for reviewing tests with sequence number decreasing. The sequence no "1" is the latest
result while sequence no "500" is the oldest test result.
2. To finish reviewing memory tests, press main button again, and you will enter the Average screen.
By pressing the right button, the display shows "AVG" on the upper right corner of the display and
the average value for the actual day. By sequencely pressing the right or left button you will get to
the 1-days, 14-days, 30-days and 90-days average of your blood glucose values.You will see the
number of the calculated days on the lower left corner and the number of the calculated readings
on the lower right corner.
40
All manuals and user guides at all-guides.com
Recalling Test Result and Average
3. Non-Averaging set and canceled:
You may select the unwanted or doubtful test results, to exclude them from the average calculation, after your
every test. After you finished your test in the test mode, you can exclude the unwanted result. Keep pressing the
right butten until you see the symbol "NO AVG" in the top right cornetr of the screen. By keeping the right button
pressed and pressing the main button simultaneously to confirm the value as "Non average".
Now this value is flagged by the symbol "NO AVG" in the up per right corner of the screen.
If you want to cancel this non-averaging setting, you have to stay in the test mode. First keep pressing the right
button until the "NO AVG" symbol changes to "AVG" in the up per right corner of the screen. To confirm this
original status you again simultaneously press the main button to confirm the "AVG" status. Now the value will be
stored as a regular value and included in the average values.
NOTE
- The average function is related to the time setting. You must set the time right and have enough time
intervals on the basis of current inquiry time, to make sure that the average test results will show. Use the
14-day average for example; if your current inquiry time is 2008/1/30, then that you must check that you
have tested blood glucose in the past 14 days before 1/30, including today. If not, the 14-day average will
show no figure.
- The Non-averaging/re-averaging function only works in the test mode and when you get the value. In the
MEM mode, you can not perform this action.
41