Publicité
Les langues disponibles
Les langues disponibles
Meter activation and Battery change
Your meter comes with two CR2032, 3volt, batteries installed. Two new batteries will provide power to
perform about 1000 tests under normal use. You can press the main button or insert a strip to
activate your meter.
NOTE
- When meter backlight has no function, you cannot see the backlight, please change your
backlight battery.
- When the backlight battery is running out of power, your meter still works properly but
without backlight function.
16
All manuals and user guides at all-guides.com
Meter activation and Battery Change
1. Turn the meter over. Press and
2. Install the battery. Be sure to
push batteries cover to open.
put battery in correct direction.
4. The meter performs a self test.
5. Press any button to exit the self-test and enter Setting Mode.
6. Set the time and date when the batteries are replaced. See Chapter "Setting up your meter -
setting the time, volume and date". Test results are still stored in the memory.
PRECAUTION
- Please follow the local regulation and discard a used battery properly.
3. Slide the battery cover
back until it snaps into
place.
17
Publicité
