Publicité
Les langues disponibles
Les langues disponibles
4. Wind the lines up firmly to the direction slown by left-hand (LH) arrow on the
flange. Do not cross the lines.
5. Wind all but about 100 mm (3-15/16") of the cords, leaving the end temporarily
hooked through a notch on the side of the spool.
6. Put tab knob onto the housing hub, positioning it can freely move up and down
against spring tension. Put the spool into the housing, aligning the teeth on
spool and tap knob alternately like gears.
7. Put in the cutting lines through the slot of eyelets.
8. Put the cover onto the housing, aligning the tabs on cover and the windows
on housing. Make sure the cover is secured exactly to the housing. Outer
edge of cover locking tab and outer surface of the housing should be on same
circumference.
All manuals and user guides at all-guides.com
19
To "LH" direction
Wind tightly
Tab knob's teeth
Cover locking tab
Outer edge
Outer
of cover
surface of
locking tab
housing
100 mm from
notches
Spool's teeth
Housing window
Publicité
