Christopeit Sport SP2000 Instructions De Montage Et D'utilisation page 18

Les langues disponibles

STEP 5

Installation of leg curler (4), leg foams (43) and arm curl

pad (81).

1. Put the leg curler (4) into the holder of leg curl frame (7)

and secure with bolt M12x85 (47), washer 12//24 (66) and

nylon nut M12 (63). Note: Don't tighten the screw for leg curler

too much. The leg curler should turn easy after assembly.)

2. Insert the leg foam holder (41) into the leg curler (4) and

seat support (7) and put the leg foams (43) onto the ends of

leg foam holder (41).

3. Adjust the arm curl pad (81) onto arm curl holder (80) so

that the threaded holes in the rear of arm curl pad (81) are

align with the arm curl holder (80) and screw it tightly by using

hex screws M8x16 (59) and washers 8//16 (68).

4. Slide the leg curl holder (80) into the appropriate holder of

leg curl frame (7) and secure it into desired position by using

the quick lock knob (24). (Note: Same procedure as quick lock

knob for seat support.)

5. Cover the screw head of screw (47) and nut (63) with cor-

responding screw cap (73).

STEP 6

Installation o buttery arm support (6), pulley support (8)

and pulley holder (27).

1. Place the buttery arm holder (6) at appropriate position

of top frame (11), push axle (77) through all holes and se-

cure with nylon nuts M12 (63) and washer 12/24 (66). (Pay

attention to the correct installation position o the buttery arm

holder (6) on top frame (11)).

2. Assemble the hand grip nut with screw (29) to the main

frame (34) and secure with bolt M8x45 (56), washer 8//16 (68)

and nylon nut M8 (65).

3. Place the pulley support (8) to the main frame (34) and

screw it on bottom area tightly with hex bolt M10x65 (49),

curved washer 10//25 (71) and nylon nut M10 (64) and on top

only with screw (49) and washer (71).

4. Insert the pulley holder (27) into the pulley support (8) and

secure with bolt M12x85 (47), washer 12/24 (66) and nylon nut

M12 (63).

5. Cover all screw heads of screws (47+49+53+56) and nuts

(63+64+65) with corresponding screw caps (73+74+75).