Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
Before beginning assembly, be sure to observe our
recommendation and safety instructions. Take out all
parts rom cartons and lay down on the oor. Some parts
are pre-assembled.
STEP 1
Installation of base frame (17), rear foot (18) and main
frame (34).
1. Place the rear foot (18) at base frame (17) in the right way
on en even oor together so that the holes align and screw
them with hex bolt 10x65 (49), at washer 10//20 (67) and
nylon nut M10 (64) tightly.
2. Place the main frame (34) onto the base frame (17) and
screw it rst vertically with carriage bolt M10x65 (53), curved
washer 10//25 (71) and nylon nut M10 (64) tightly. Then tighten
the main frame (34) horizontally to the base frame (17) with
hex bolt M10x70 (48), at washer10//20 (67) and nylon nut
M10 (64).
3. Place the backrest (13) at the main frame (34) and screw
tightly by using hex bolt M8x65 (54) and curved washer 8//25
(72). Then mount the head pad (107) in the same way as the
back pad (13).
4. Cover all screw heads of screws (48+49+54) and nuts (64)
with corresponding screw caps (74+75).
STEP 2
Installation of sliding tubes (5) and weights (31+32).
1. Insert the sliding tubes (5) into the holes of rear foot (18)
and x them with hex bolt M8x60 (55), washer 8//16 (68) and
nylon nut M8 (65). Then cover all screw heads of screws (55)
and nuts (65) with screw caps (75+76).
Slide the bottom cover bracket (22), 2 rubber bumper (10),
the weight supports (83) and again 2 rubber bumper (10) onto
the sliding tubes (5). (Note: If you bought the option weight set
Art.-No. 9389 you put on the 2 additional weight plates (32)
instead of the weight supports (83)(Fig. 1). Then slide
the weight plates (32) over the sliding tubes (5) in correct
direction so that the locking pin (30) can be positioned under
the weight plate.
2. Slide the plastic ring (35) onto the pull rod (36) and secure
with limit bolt (37) in uppermost hole. Insert the pull rod (36)
into the weights (32).
3. Slide the rst weight plate (31) onto the sliding tubes (5)
and put the plastic washer 13//40 (1) on top.
4. Put the 2 adjustment screws (33) into the appropriate holes
o top cover bracket (82) as gure 2 shows and x them with
washers 8//16 (68) and nylon nuts M8 (65).
5. Slide the top cover bracket (82) onto the sliding tubes (5)
and insert the security pin (30). To adjust the weights, use the
security pin (30) and put it into desired position of the pull rod
(36). In this case, the higher the locking pin (30) is inserted, the
lower the weight load.
107
13
74
64
71
71
17
53
5
1
31
35
36
22
76
16
34
72
54
75
74
18
49
67
64
74
67
48
33
82
68
65
37
32
30
10
75
68
55
68
18
65
GB
67
83
Publicité
