Christopeit Sport SP2000 Instructions De Montage Et D'utilisation page 17

Les langues disponibles

STEP 3

Installation of top frame (11) and end tube (44).

1. Insert the end tube (44) in right direction on top of the

sliding tubes (5) and screw tightly with hex bolt M10x25 (52)

and curved washer 10//25 (71).

2. Place the top frame (11) onto the main frame (34) and

screw it loosely together by using carriage bolt M10x65 (53),

washer 10//25 (71) and nylon nut M10 (64). Additional secure

this point loosely with screws M8x25 (57), washers 8//16 (68),

bushing (70) and nylon nut M8 (65). Then put the holder of top

frame (11) and end tube (44) together and screw tightly with

screws M10x65 (49) curved washers 10//25 (71) and nylon

nuts M10 (64). Also tighten now the screws (53+57).

STEP 4

Installation of leg curl frame (7), seat (14) and seat

support (79).

1. Place the leg curl frame (7) with holder in front of the main

frame (34) and the balance frame (2) on rear side of main

frame (34) and screw tightly by using bolt M10x70 (48), curved

washer 10//25 (71) and nylon nut M10 (64).

2. Adjust the seat (14) on seat support (79) so that the

threaded holes in the rear of seat (14) are align with the seat

support (79) and screw it tightly by using washers 6//16 (69)

and screws M6x15 (60).

3. Slide the seat support (79) into the appropriate holder of

leg curl frame (7) and secure it into desired position by using

the quick lock knob (24). (Note: To screw in the quick lock knob

(24), the treaded hole in the leg curl frame (7) and one of the

holes in the seat support (79) must be aligned. The setting of

the seat can be adjusted as desired later. For this, the quick

lock knob (24) must be loosened by only a few revolutions, the

cap of the lock must be pulled away and the seat adjusted.

Then secure the new setting by tightening the quick lock knob

(24).)

4. Cover all screw heads of screws (48) and nuts (64) with

screw caps (74).

3. Push the adjustment screws (33) (with top cover bracket

(82)) through the holes of end tube (44) and secure on top with

curved washer 8//25 (72) and buttery nut (62).

4. Cover all screw heads of screws (49+52+57) and nuts

(64+65) with corresponding screw caps (74+75+76).