Télécharger Imprimer la page

Fein CCG18-125-10PD-SEC AS Mode D'emploi page 29

Masquer les pouces Voir aussi pour CCG18-125-10PD-SEC AS:

Publicité

Les langues disponibles

Les langues disponibles

en
29
Cleaning contact surfaces (figure 15).
Fig. 15
Contact surface
Clean the contact surfaces on the power
tool at regular intervals before adjusting the
handle.
Warranty and liability.
The warranty for the product is valid in accordance with the legal regulations in the country
where it is marketed. In addition, FEIN also provides a guarantee in accordance with the
FEIN manufacturer's warranty declaration.
Not all accessories described or shown in this instruction manual will be included with your-
power tool.
Environmental protection, disposal.
Do not dispose of the batteries into household waste!
Packaging, worn out power tools and accessories should be sorted for environmental-
friendly recycling.
Dispose of batteries only when discharged.
For batteries that are not completely discharged, insulate the terminals with tape as a pro-
tective measure against short-circuiting.
Transport.
The Li-ion batteries are subject to the Dangerous Goods Legislation requirements. The user
can transport the batteries by road without further requirements.
When being transported by third parties (e.g.: air transport or forwarding agency), special
requirements on packaging and labelling must be observed. For preparation of the item
being shipped, consulting an expert for hazardous material is required.
Dispatch batteries only when the housing is undamaged. Tape or mask off open contacts
and pack up the battery in such a manner that it cannot move around in the packaging. Please
also observe possibly more detailed national regulations.

Publicité

loading