Fein CCG18-125-10PD-SEC AS Mode D'emploi page 25

Features
The soft start is used to reduce torque reac-
tion forces when switching on and running
up the power tool to the no-load speed.
The restarting protection prevents the
power tool from automatically restarting if
the power supply is interrupted during
operation. In this case, switch off the power
tool, check the power supply and then
switch the power tool on again.
The blocking monitor reduces the risk of
motor damage and the risk of accidents
when an application tool blocks. In this case,
the power tool switches off automatically.
Afterwards, set the switch to the off posi-
tion, remove the power tool from the
workpiece and check the application tool
for damage. Afterwards, switch the power
tool on again.
The electronic overload protection reduces
the risk of motor damage if the power tool
is overloaded. In this case, the power tool
switches off automatically. Afterwards, set
the switch to the off position, remove the
power tool from the workpiece and check
the application tool for damage. Afterwards,
switch the power tool on again.
Additional operating instructions.
The self-start prevention lock prevents the
power tool from automatically starting
when the battery is inserted while the on/off
switch is set to on.
If the power tool shuts off without the
switch being actuated, switch the power
tool switch off, remove the battery and reat-
tach it.
The electronic speed preselection enables
the speed to be adapted to the respective
application and the respective application
tool.
The dead man's switch is a non-lockable
switch. The dead man's switch must be con-
tinuously actuated to keep the power tool in
operation.
The power tool is equipped with a brake
system for braking down the application
tool. This reduces the risk of accidents.
The kickback monitoring reduces the risk of
unexpected kickback of the power tool. In
this case, the power tool switches off auto-
matically. Afterwards, set the switch to the
off position, remove the power tool from
the workpiece and check the application
tool for damage. Afterwards, switch the
power tool on again.
The kickback monitoring reduces the risk of
unexpected kickback of the power tool. In
this case, the power tool switches off auto-
matically. Afterwards, set the switch to the
off position, remove the power tool from
the workpiece and check the application
tool for damage. Afterwards, switch the
power tool on again.
en
25