Fein CCG18-125-10PD-SEC AS Mode D'emploi page 27

Securing the workpiece (figure 12).
Secure the workpiece sufficiently. An
inadequately secured workpiece can,
for example, cause the grinding acces-
sory to jam. This can lead to kickback,
cause the workpiece to fall down, and
lead to other dangerous situations.
Dry grinding (figure 13).
Observe a lead angle of 20 – 40°. This will
ensure a good removal rate.
Apply uniform pressure with the
power tool and move it over the sur-
face.
Avoid excessive heating of the work-
piece surface.
Cutting (figure 14).
Always work in an up-grinding motion,
so that the cutting disc will not jump
out of the cut.
For cut-off grinding work,
WARNING
use the safety cover
included in the delivery scope for additional
personal protection. The safety cover helps
to protect the operator from fragments,
accidental contact with the grinding acces-
sory as well as sparks that could ignite cloth-
ing.
Fig. 12
Fig. 13
Fig. 14
4-1
en
27
1-1
1-2
4-1