Publicité
Les langues disponibles
Les langues disponibles
en
22
Changing the tool.
Before mounting or replacing application tools or accessories, remove the
WARNING
battery. This preventive safety measure rules out the danger of injuries
through accidental starting of the power tool.
Mounting a grinding disc (figure 7).
Press the locking button only when the
motor is stopped. Otherwise the power
tool may be damaged.
Press the locking button fully through and
hold it in place. Loosen the quick-clamping
nut.
Unscrew the quick-clamping nut.
Replace the used-up grinding accessory
or insert a new one.
Pay attention that the grinding acces-
sory is properly centered between the
support flange and the quick-clamping
nut.
Fig. 7
2.
1. 1.
3. 3.
4.
Manually screw on the clamping flange again.
Press the locking button fully through and
hold it in place. Tighten the quick-clamping
nut.
Note:Observe the mounting direction of the
quick-clamping nut.
Offset grinding discs must be mounted in
such a manner that their grinding surface is
2 mm below the bottom edge the of the
wheel guard. Grinding accessories that do
not meet these requirements cannot be ade-
quately covered off and are not permitted.
2.
3. 3. 3.
1.
4. 4. 4.
Publicité
