Fault And Breakdown Code Display; Code Description; Accessing Memorised Data - SOMFY CONTROL BOX 3S io Manuel D'installation

Control Box 3S io

fault and breakdown code display

Code description
E1 Cell safety autotest fault
E2 Programmable safety autotest
fault
E4 Obstacle detection when
opening
E5
Obstacle detection when
closing
E6 Cell safety fault
E8 Programmable safety fault
E9 Thermal protection
E10 Motor short circuit protection
24V power supply short
E11
protection
Hardware fault
E12
E13 Accessories power supply fault The accessories power supply cuts out following an
E14 Intrusion detection
E15 Fault when the control box
supplied by the backup battery
is first switched on
For all other error codes or faults, please contact Somfy.

Accessing memorised data

To access memorised data, select parameter "ud" then press "OK".
data description
u0 to u1 Complete opening cycle
counter
u2 to u3
u6 to u7 Cycle counter with obstacle
detection
u8 to u9
u12 to u13 Pedestrian opening cycle counter
u14 to u15 Reset movement counter
u20
Number of monodirectional remote controls memorised for complete opening control
u21
Number of monodirectional remote controls memorised for pedestrian opening control
u22
Number of monodirectional remote controls memorised for remote lighting control
u23 Number of monodirectional remote controls memorised for auxiliary output control
u24 0 = no system key present, 1 = system key present
d0 to d9 Log of the last 10 faults (d0 most recent - d9 oldest)
dd To clear the fault log: press and hold "OK" for 7 s.
21
Comments
The cell autotest is not satisfactory.
The programmable safety input autotest is not
satisfactory.
Detection in progress on safety input for longer than
3 minutes.
Thermal protection is correct
Short circuit protection for input/outputs: product
and additional devices connected to terminals
21 to 26 (orange light, photoelectric cells (except
BUS), code keypad) not operating
The hardware auto tests are not satisfactory
overload (excessive consumption)
Current reinjection function
global [Hundred thousands - ten thousands - thousands] [hundreds - tens - units]
since last auto-programming [Hundred thousands - ten thousands - thousands] [hundreds - tens - units]
global [Hundred thousands - ten thousands - thousands] [hundreds - tens - units]
since last auto-programming [Hundred thousands - ten thousands - thousands] [hundreds - tens - units]
Solution?
Check that "P07" is correctly configured.
Check the wiring of the cells.
Check that "P09" is correctly configured.
Check the programmable safety input wiring.
Check that no obstacles are causing the cells or safety edge to detect.
Check that "P07 or P09" is correctly configured in relation to the device
connected to the safety input.
Check the safety device wiring.
Check that the photoelectric cells are correctly aligned.
Check the motor wiring.
Check the wiring, then disconnect the power supply for 10 seconds.
N.B.: maximum accessories consumption = 1.2 A
Repeat an order. If the fault persists, contact Somfy.
N.B.: maximum accessories consumption = 1.2 A
Check the consumption of the connected accessories.
Normal operation (attempted intrusion, current reinjection activated, etc.)
Disconnect the backup battery and connect the control box to the mains to
switch it on for the first time.
Copyright © 2015 Somfy SAS. All rights reserved