Memorising 3-Button Remote Controls (Telis Io, Telis Composio Io, Etc.) - SOMFY CONTROL BOX 3S io Manuel D'installation

Masquer les pouces Voir aussi pour CONTROL BOX 3S io:

Manuel d'utilisation (96 pages)

Manuel d'installation (52 pages)

Guide rapide (2 pages)

Table des Matières

Les langues disponibles

Control Box 3S io

• Copying individual buttons on the Keytis io remote control

This operation is used to copy the memorisation of a single button on a previously memorised remote control to a blank button on a new remote control.

Ensure that the new remote control has memorised the system key.

[1]. Press the "pROg" button on the memorised remote control until the green indicator light comes on (2 s).

[2]. Briefly press the button to be copied on the previously memorised remote control.

[3]. Briefly press the "pROg" button on the new remote control.

Wait for the confirmation beep (a few seconds).

[4]. Briefly press the selected button to actuate the motor on the new remote control.

Remote control memorised

It is not possible to memorise Keytis io remote controls in the following cases:

. The remote control has not memorised the system key.

. Several of the installation's receivers are in programming mode.

. Several remote controls are in key transfer or memorisation mode.

Incorrect memorisation is indicated by a rapid series of beeps accompanied by a flashing orange indicator light on the Keytis remote

control.

Memorising 3-button remote controls (Telis io, Telis Composio io, etc.)

Button functions on a 3-button remote control

Complete opening

Lighting ON

Aux. output ON

Memorising via the programming interface

To memorise a 3-button io bidirectional remote control (Telis io, Impresario Chronis io, etc.), ensure that the remote control has memorised the system

key (see page 16).

[1]. Press and hold the "pROg" button (2 s) on the programming interface.

The screen displays "f0".

Note: pressing "pROg" again allows the next function to be memorised.

[2]. Press "pROg" at the rear of the 3-button remote control to memorise the

function.

The screen displays "Add".

Memorising by copying a previously memorised 3-button io remote control

Stop

Complete closing

Stop

Complete closing