Clearing The Remote Controls And All Settings; Clearing Individual Buttons On The Keytis Io Or Keygo Io Remote Controls; Clearing The Memorised Remote Controls; Keytis Io Remote Control General Reset - SOMFY CONTROL BOX 3S io Manuel D'installation

Control Box 3S io

CLEARINg ThE REMOTE CONTROLS ANd ALL SETTINgS

Clearing individual buttons on the Keytis io or Keygo io remote controls

This can be done:
• by memorising via the programming interface.
Memorising a button which has already been memorised will clear this button's function.
• by clearing directly on the remote control (only on Keytis io remote controls).
Press the "pROg" button and the BuTTON to be cleared on the remote control together.

Clearing the memorised remote controls

Causes all memorised remote controls and the memorised system key to be cleared.
Note: On Keytis io remote controls, repeat the direct clearing procedure described above for all of the memorised remote control buttons.
C1

Keytis io remote control general reset

Press the "pROg" and "KEY" buttons together. This causes:
• the programming to be completely cleared (all buttons),
• all the settings on the remote control to be cleared (refer to the instructions for the Keytis io
remote control),
• the system key memorised by the remote control to be modified.

Clearing all settings

Clears the auto-programming and resets the default values for all parameters.

LOCKINg ThE pROgRAMMINg BuTTONS

The programming buttons must be locked to ensure the safety of the users.
When the programming buttons are locked, a dot appears after the 1st digit.
Press the "SET", "+" and "-" buttons.
- the "SET" button must be pressed first.
- the "+" and "-" buttons must be pressed simultaneously within 2 seconds.
To access the programming again, repeat this procedure.
19
f0 rSt
7 s
+ +
C1
7 s
C.1
C1
Copyright © 2015 Somfy SAS. All rights reserved
C1
h1 - - - h0