Reely 1:8 GP Buggy Ultra Sonic 4WD RtR Notice D'emploi page 76

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Engine or fuel system
The engine does not start.
Engine does not receive any fuel
Engine starts, but stops again
Engine does not run correctly,
responds badly
76
Defect glow plug or empty start battery
Start battery defect
Fuel tank is empty or carburettor not filled
Carburettor is not adjusted correctly
Fuel is old or contaminated
Combustion chamber is full of fuel (drowned)
Additional air is sucked in via fuel line or engine
Servo linkage is not adjusted correctly
Fuel line, air filter or exhaust are clogged
Main nozzle needle is twisted in all the way
Idle mix is too lean
Fuel hoses are bent
Fuel tank is defect
Fuel tank is empty
Fuel line, air filter or exhaust are clogged
Carburettor is not adjusted correctly
Engine is overheated
Wrong or defect glow plug
Wrong or old fuel
Dirty air filter
Mix is too fat
Idle mix is too lean
Idle mix is too fat
Additional air is sucked in via fuel line or engine
Insufficient pressure of exhaust pipe
Change the glow plug, charge start battery
Replace start battery
Fill the fuel tank and pump fuel to the carburettor
Readjust idle and main nozzle needle
Replace fuel and check the fuel filter
Unscrew the spark plug and proceed as described in the
respective section
Check/replace the fuel hoses and/or tighten all engine
screws
Place the servo in neutral position and readjust
Clean blocked parts, if necessary, replace
Reset main nozzle to factory settings
Reset idle mix adjustment screw to factory settings
Check and straighten the fuel hoses
Replace the fuel tank
Fill the fuel tank
Clean blocked parts, if necessary, replace
Readjust idle and main nozzle needle
Check the temperature Above 150°, the fuel mix must be
enriched
Check whether the wheels turn freely
Insert the glow plug
Fill in the correct fuel
Wash it and then apply air filter oil
Set the main nozzle needle to a lean mix
Reset idle mix adjustment screw to factory settings
Reset idle mix adjustment screw to factory settings
Check/replace the fuel hoses and/or tighten all engine
screws
Check the exhaust pipe and replace if necessary

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

23 60 15

Table des Matières